Press button once or turn the light on and off.Completely close app (Please check your phone manufacturers guide on how to do this.).The light will then flash its LED's on the rear green to confirm that the lights has reset.With light off, press and hold on/off button, you will see a series of rapid flashes, then release after 12 flashes.Press and hold striped button for approx 10 seconds until you see a green flash.Press stripe button once - returns green flash.This is completely normal and was programmed into the light to let you know if the light is on or sleeping. If there is a remembered phone bonding on the light it will not pair to another phone. Go into the phone and delete the paired device/ remembered device from Bluetooth settings. This will not delete the program modifications. Light won’t connect to my phone after connecting it to someone else’s phoneĭelete the bonding to the light by going to program 12. Occasionally a light will miss a command from the remote causing the lights to become out of sync, just press the button on the back of the light to change its mode to match the other. On some rare occasions it might be that your SYNC lights need to be reset particularly if you've had them synced to different remotes in the past.Ĭheck that both lights have the same number of modes on the program (3 or 2). This may take 4/5 goes in a Bluetooth ‘noisy’ environment. Keep trying by pressing striped button to renew pairing sequence as it could be caused by too much interference. If both the light and remote have been paired together, but wont ‘wake up’, just flash orange. Light wont pair with remote, just flashes orange. Wake with one stripe press, (green flash), continue to pair as normal.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |